Contemporary Clinical Dentistry
   
  Home | About us | Editorial board | Search
Ahead of print | Current Issue | Archives | Advertise
Instructions | Online submission| Contact us | Subscribe |

 

Login  | Users Online: 2285  Print this pageEmail this pageSmall font sizeDefault font sizeIncrease font size 

ORIGINAL ARTICLE
Year : 2019  |  Volume : 10  |  Issue : 2  |  Page : 338-343

Influence of diode laser on the bond strength of self-etching adhesive systems to human dentin: An in vitro study


Department of Conservative Dentistry, Mallareddy Dental College for Women, Hyderabad, Telangana, India

Correspondence Address:
Dr. Nimeshika Ramachandruni
Department of Conservative Dentistry, Mallareddy Dental College for Women, Hyderabad, Telangana
India
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/ccd.ccd_589_18

Rights and Permissions

Introduction: The treatment of dental tissues before adhesive restorative procedures is an important step in the bonding protocol and determines the clinical success of restorations. Aim: The aim of this study is to evaluate in vitro the influence of diode laser on the shear bond strength of one- and two-step self-etch (SE) adhesives to dentin when the laser is applied over the adhesives before photopolymerization. Methodology: About 20 freshly extracted noncarious intact maxillary premolars were collected, and the buccal and lingual surfaces of the tooth were ground with the help of diamond disk under water coolant till dentin was exposed. The specimens were divided into two groups of 10 each. Buccal surfaces of all the specimens were exposed to diode laser before light curing (test/experimental group) act as control group. In Group I, Clearfil SE with laser was used on the buccal surface, whereas in Group II, G-bond SE adhesive with laser was used on the buccal surface. Shear bond test was measured using an universal testing machine and the values were obtained in megapascals (MPa). Results: P < 0.05 was considered statistically significant. According to the results, it was found that the mean bond strength values of the laser-treated groups were significantly higher than groups not treated with laser. Conclusion: Within the limitations of this study, it can be concluded that mean bond strength Clearfil SE with and without laser was significantly higher than G-bond with and without laser values.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed41    
    Printed0    
    Emailed0    
    PDF Downloaded6    
    Comments [Add]    

Recommend this journal