Contemporary Clinical Dentistry
   
  Home | About us | Editorial board | Search
Ahead of print | Current Issue | Archives | Advertise
Instructions | Online submission| Contact us | Subscribe |

 

Login  | Users Online: 3117  Print this pageEmail this pageSmall font sizeDefault font sizeIncrease font size 



 
 Table of Contents  
CASE REPORT
Year : 2011  |  Volume : 2  |  Issue : 1  |  Page : 63-65  

Oral rehabilitation of a patient with sub - total maxillectomy


1 Department of Prosthodontics, Faculty of Dental Sciences, Institute of Medical Sciences, Banaras Hindu University, Varanasi, India
2 Department of Conservative Dentistry, Faculty of Dental Sciences, Institute of Medical Sciences, Banaras Hindu University, Varanasi, India
3 Department of Orthodontics, Government Dental College, Bangalore, India
4 Department of Prosthodontics, Government Dental College, Bangalore, India

Date of Web Publication12-Apr-2011

Correspondence Address:
Romesh Soni
Department of Prosthodontics, Faculty of Dental Sciences, Institute of Medical Sciences, Banaras Hindu University, Varanasi - 221 005
India
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/0976-237X.79293

Rights and Permissions
   Abstract 

This clinical report describes oral rehabilitation of a patient with sub-total maxillectomy with palatine process of maxilla and horizontal plate of palatine bone intact to retain the maxillary obturator. Clinical examination has been performed to know the amount of favorable undercuts to be used for retention of the obturator for better functional efficiency. Successful prosthetic reconstruction of hemimaxillectomy defect is a challenging procedure that requires multidisciplinary expertise to achieve acceptable functional speech and swallowing outcomes. This article describes the oral rehabilitation of a patient with sub-total maxillectomy with a maxillary obturator. Oral rehabilitation of sub-total maxillectomy patient is a challenging task. Obturation of the defect depends on volume of the defect, and positioning of remaining hard and soft tissues to be used to retain, stabilize, and support the prosthesis. A maxillary obturator for edentulous patient must provide for retention, stability, support, patient comfort, and cleanliness.

Keywords: Maxillary obturator, oral rehabilitation, retention, stability, sub-total maxillectomy


How to cite this article:
Soni R, Jindal S, Singh B P, Mittal N, Chaturvedi T P, Prithviraj D R. Oral rehabilitation of a patient with sub - total maxillectomy. Contemp Clin Dent 2011;2:63-5

How to cite this URL:
Soni R, Jindal S, Singh B P, Mittal N, Chaturvedi T P, Prithviraj D R. Oral rehabilitation of a patient with sub - total maxillectomy. Contemp Clin Dent [serial online] 2011 [cited 2019 Nov 19];2:63-5. Available from: http://www.contempclindent.org/text.asp?2011/2/1/63/79293


   Introduction Top


A maxillary oral squamous cell carcinoma (SCC) is generally treated with a conventional surgical excision. The resultant surgical defect often includes part of the hard and soft palates, which results in an oro-antral communication. [1]

The hard and soft palates are anatomical structures that have widely recognized roles in speech and deglutition. When these structures must be removed, partially or completely, because of malignancies, a team approach is critical. A surgical approach alone without reconstruction or obturation of the surgical defect will result in air, liquid, and food escaping into the maxillary sinus and nasal cavities, causing severe speech and swallowing dysfunction with significant reduction in quality of life. [2]

Speech is often unintelligible as a result of the marked defects in articulation and nasal resonance resulting from the anatomical and structural defect. Thorough pre- and postsurgical reconstructive and prosthetic treatment planning will ensure the best rehabilitation of a maxillectomy patient. [3]

Numerous techniques and materials for making obturators have been suggested. [4],[5],[6],[7],[8],[9],[10],[11],[12],[13],[14],[15],[16],[17] This clinical technique describes oral rehabilitation of a patient with sub-total maxillectomy with a maxillary obturator.


   Case Report Top


A 55-year-old female diagnosed with SCC of the right maxillary sinus had undergone hemimaxillectomy. She had a recurrence on the left side and was reoperated. Sub-total maxillectomy was performed and after proper healing, she was referred to the Department of Prosthodontics, Government Dental College, Bangalore, India.

The patient's chief concerns were relative to speech, mastication, and esthetics. Extra-oral examination revealed reduced fullness due to loss of support [Figure 1]. On intraoral examination, a big communication was present between nasal and oral cavity except a minor part of the palatine process of maxilla and horizontal plate of palatine bone [Figure 2].
Figure 1: Pre-treatment photograph showing reduced fullness

Click here to view
Figrure 2: Intra-oral photograph showing the defect

Click here to view


Speech pathology, head and neck, and maxillofacial prosthetics/dental oncology services were consulted to evaluate the extent of resection and functional deficits. A consensus among the specialists recommended an obturator to restore speech and swallowing abilities and esthetics.

An irreversible hydrocolloid impression was made with a stock tray [Figure 3]. The impression was boxed and poured in type IV stone (Ultrarock, Kalabhai Karson Pvt. Ltd, Mumbai) [Figure 4]. Undercuts on the cast were blocked. Record bases were made with heat cure acrylic resin (Lucitone 199, Dentsply Int.) [Figure 5].The jaw relation was recorded. After the try-in, the solid obturator was processed in heat polymerized acrylic resin (Lucitone 199, Dentsply Int.).
Figure 3: Maxillary impression along with the defe

Click here to view
Figure 4: Master cast showing the resected area

Click here to view
Figure 5: Heat-cure acrylic record base

Click here to view


After curing of the prosthesis, the flash was trimmed. The prosthesis was pumiced, polished, and delivered to the patient [Figure 6], [Figure 7] and [Figure 8]. The patient was instructed to correctly position, remove, and clean the prosthesis.
Figure 6: Maxillary obturator in patient's mouth

Click here to view
Figure 7: Patient's frontal view along with the prosthesis

Click here to view
Figure 8: Post -treatment photograph with increased fullness and improved esthetics

Click here to view


The prosthetic retention and stability were evaluated subjectively. Speech intelligibility improved and the patient was then referred to the speech pathology department for further evaluation of his speech and swallowing abilities. The patient returned a week later for a follow-up appointment. He was satisfied with esthetics and function of the prosthesis.


   Discussion Top


Obturator prosthesis for maxillary defects is frequently associated with problems that result from the lack of retention and stability. Maxillofacial reconstruction of the partition between the nasal and oral cavities in the edentulous patient relies on anatomical undercuts and structures, such as remnants of the soft palate, palatine process of maxilla, and horizontal plate of palatine bone, for retention. [3]

An appropriate prosthetic fit and functional success ensure that the patient ultimately uses the device during daily routines. It is important that clinicians do not overlook the importance of referral to the speech pathologist, particularly in patients for whom the success of a prosthetic obturator after total or sub-totalmaxillectomy depends on the ability to adequately speak and swallow.


   Summary Top


Subtotal and total bilateral maxillectomydefects represent a complex challenge for the maxillofacial prosthodontist. In this clinical report, preoperative treatment planning involving the head and neck surgeon, the maxillofacial prosthodontist, and the speech pathologist resulted in a obturator that enabled the patient to speak and swallow successfully.

 
   References Top

1.CW Cummings, Cummings otolaryngology: Head and Neck Surgery. 4 th ed. St. Louis: Elsevier; 2004. p. 1604-8.th   Back to cited text no. 1
    
2. Jacob FJ. Clinical management of the edentulous maxillectomy patient. In: TD Taylor, editor. Clinical maxillofacial prosthetics. Chicago: Quintessence; 2000. p. 85-7.  Back to cited text no. 2
    
3.Beumer J, Curtis D, Firtell D. Restoration of acquired hard palate defects: Etiology, disability and rehabilitation. In: Beumer J 3 rd , Curtis TA, Marunick MT, editors, Maxillofacial rehabilitation: prosthodontic and surgical considerations. St. Louis: Medico Dental Media Intl; 1996. p. 225-84.  Back to cited text no. 3
    
4.Mahdy AB. Processing a hollow obturator. J Prosthet Dent 1969;22:682-6.  Back to cited text no. 4
    
5.Chalian VA, Barnett MB.A new technique for constructing a one-piece hollow obturator. J Prosthet Dent 1972;28:448-51.  Back to cited text no. 5
    
6.Matalon V, La Fuente H. A simplified method for making a hollow obturator. J Prosthet Dent 1976;36:580-2.  Back to cited text no. 6
    
7.Tanaka Y, Gold HO, Pruzansky S. A simplified technique for fabricating a light weight obturator. J Prosthet Dent 1977;38:639-42.  Back to cited text no. 7
    
8.Parel SM, La Fuente H. Single-visit hollow obturators for edentulous patients. J Prosthet Dent 1978;40:426-9.  Back to cited text no. 8
    
9.Schneider A. Method of fabricating a hollow obturator. J Prosthet Dent 1978;40:351.  Back to cited text no. 9
[PUBMED]    
10.Guelde DJ. Pre-fabricated hollow bulb obturator technique. Quintessence Dent Tech 1980;6:65.  Back to cited text no. 10
    
11.Holt RA Jr.A hollow complete lower denture. J Prosthet Dent 1981;45:452-4.  Back to cited text no. 11
[PUBMED]    
12.Worley JL, Kniejski ME. A method for controlling the thickness of hollow obturator prosthesis. J Prosthet Dent 1983;50:227-9.  Back to cited text no. 12
[PUBMED]  [FULLTEXT]  
13.Elliott DJ. The hollow bulb obturator: Its fabrication using one dental flask. Quintessence Dent Tech 1983;7:13-4.  Back to cited text no. 13
    
14.Knapp JG. A simplified approach to the fabrication of a maxillary obturator prosthesis. J Prosthet Dent 1984;51:67-9.  Back to cited text no. 14
[PUBMED]    
15.Browning JD, Kinderknecht J. Fabrication of a hollow obturator with fluid resin. J Prosthet Dent 1984;52:891-5.  Back to cited text no. 15
[PUBMED]  [FULLTEXT]  
16.Radcliffe GJ, Mady S, Burr R, Cheesman AD, Wilson D. A new immediate temporary light weight obturator for maxillectomy cavities. Br J Oral Maxillofac Surg 1984;22:50-3.  Back to cited text no. 16
[PUBMED]    
17.Minsley GE, Nelson Dr, Rothenberger SL. An alternative method for fabrication of a closed hollow obturator. J Prosthet Dent 1986;55:485-90.  Back to cited text no. 17
[PUBMED]    


    Figures

  [Figure 1], [Figure 2], [Figure 3], [Figure 4], [Figure 5], [Figure 6], [Figure 7], [Figure 8]


This article has been cited by
1 Maxillary V-4: Four implant treatment for maxillary atrophy with dental implants fixed apically at the vomer-nasal crest, lateral pyriform rim, and zygoma for immediate function. Report on 44 patients followed from 1 to 3 years
Ole T. Jensen,Mark W. Adams,Caesar Butura,Daniel F. Galindo
The Journal of Prosthetic Dentistry. 2015; 114(6): 810
[Pubmed] | [DOI]



 

Top
 
  Search
 
    Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
    Access Statistics
    Add to My List *
* Registration required (free)  

 
  In this article
    Abstract
    Introduction
    Case Report
    Discussion
    Summary
    References
    Article Figures

 Article Access Statistics
    Viewed3067    
    Printed122    
    Emailed1    
    PDF Downloaded295    
    Comments [Add]    
    Cited by others 1    

Recommend this journal